Untitled Document

1. Position UNIT near an electrical outlet close to your application.

2. Place the UNIT so that is at least 12 inches from any obstruction whatsoever. DO NOT PLACE the UNIT near any heat, flame, fire, curtains, or drapes.

3. Position the UNIT so that the operating controls and the oxygen outlet hose are easily accessible.

4. Unwind the power cored completely from around the UNIT and insert it into the proper electrical outlet.

5. Locate the POWER SWITCH on the front of the UNIT and switch it to the "l" or ON position.

Home Oxygen System #1 Instructions
1. Position UNIT near an electrical outlet close to your application. 2. Place the UNIT so that is at least 12 inches from any obstruction whatsoever. DO NOT PLACE the UNIT near any heat, flame, fire, curtains, or drapes. 3. Position the UNIT so that the operating controls and the oxygen outlet hose are easily accessible. 4. Unwind the power cored completely from around the UNIT and insert it into the proper electrical outlet. 5. Locate the POWER SWITCH on the front of the UNIT and switch it to the "l" or ON position.
6. Set the FLOWMETER CONTROL to the required Oxygen Flow. The pressure compensation flowmeter delivers approximately 6 LPM of oxygen when set to 60% flow; 3.8 LPM at 40% flow; and 3 LPM at 30% flow. *Setting the flow meter above 60% flow will result in reduced oxygen purity (less than 90%). 7. To turn the UNIT off, press the POWER SWITCH on the front of the UNIT to the "O" position. 8. DO NOT SMOKE or use FIRE/FLAME near the UNIT or for 30 minutes after using the UNIT.
*The "Home Oxygen System #1" is not intended for Medical Use.